Conference Bridge Controls for Leader

Conference Bridge Controls for Leader

Use the following star codes while joined into a conference bridge as a leader. 

[*]6Toggle MuteToggle Mute On/Off
[*]71Start RecordingRecording On
[*]73Stop RecordingRecording Off
[*]74Dec Rx GainDecrease volume to participant
[*]75Reset RxGainReset volume to participant
[*]76Inc RxGainIncrease volume to participant
[*]77Dec Tx GainDecrease volume to conference
[*]78Reset TxGainReset volume to conference
[*]79Inc Tx GainIncrease volume to conference
[*]91List ParticipantsTo announce the list of active participants
[*]92Toggle Announce On/OffToggle Annoucement On/Off
[*]93Disconnect AllDisconnect All Other Participants
[*]94Toggle Conference LockToggle Conference Lock
[*]95Count ParticipantsTo announce the count of active participants
[*]96Mute AllMute All Other Participants
[*]97Unmute AllUnmute All Other Participants

    • Related Articles

    • Disposition Codes

      Introduction In a call center environment, it is important to understand the reason for and the outcome of inbound and outbound calls. Within the PressONE system, it is possible for agents to denote Call Disposition and Call Reasons as related to ...
    • How to use Call Center Reporting

      Concept Call Center Reporting is for HISTORICAL reporting on Call Centers and their Agents.  There a few real-time statistics within the Call Center tab on the portal, however, active wall board metrics would be in the Analytics Section.  Stats Grid ...
    • Device Overrides

      Concept Overrides are custom lines of code for devices to extend, change, or supersede the the default configuration. All Overrides must be done in the Manager Portal (OMP). Overrides can be added directly to a phone, device template or a Site.. ...
    • Factory Resetting Common SIP Phones

      Yealink T2, T3, T4, T5 (Except Android Phones), CP920 Press the “OK” button for 5 seconds. Depending on the specific configuration, the device may ask for the admin password. If you do not know it, please contact your account rep or ...