Enabling and Setting Up Wifi on your Yealink T53W, T54W, T57W and Wifi Adapter enabled IP Phones

Enabling and Setting Up Wifi on your Yealink T53W, T54W, T57W and Wifi Adapter enabled IP Phones

Enabling Wifi on Yealink SIP-T53W, T54W, T IP Phone

  1. Go to Menu > Basic > Wi-Fi (for the T53W, Menu > Settings > Basic Settings > WiFi)
  2. Choose [x] Available Network[s], where "x" is the number of available networks
  3. Choose Enter
  4. Choose the Desired Wi-Fi network
  5. Choose Connect 
  6. Enter the password 
  7. Choose OK. 

Here is how to add a Wi-Fi Network Mannually (if your SSID is not broadcasting for example) 

  1. Go to Menu > Basic > Wi-Fi (for the T53W, Menu > Settings > Basic Settings > WiFi)
  2. Choose Known Network[s]
  3. Choose Add
  4. Choose the Appropriate Security Mode
  5. Enter the Wi-Fi network name, password, and other information. 
  6. Choose Save


    • Related Articles

    • Increase Microphone Gain (volume) on Yealink Devices

      Introduction Sometimes Yealink phone users complain that the remote side of the call has difficulty hearing b/c the volume is too low. You can raise the microphone gain on the Handset, Headset or Handsfree (Speaker) by following these steps Procedure ...
    • Pair Handset with Yealink W60B

      How to register a Yealink handset with a single W60B or multiple base stations The following steps may also apply to Yealink models W52B and W80B. With a Single W60B Hold down the Connect button on the base until the top light of the three green ...
    • Compliance Documention for POTS Replacement

      Our POTS Replacement Solution is fully compliant with PCI, HIPAA, FCC, NFPA, and UL privacy requirements. Fire Panel Compliance There are very specific standards and regulations when it comes to services that connect to fire alarms.POTS Replacement ...
    • Adding Grandstream GXW devices to GDMS

      Fun fact if anyone ever wants to use GDMS for the GXW gateways. The process is a bit backwards. Do not add the gateway to GDMS until you manually provision the device. Add your users in the Domain Add your Gateway in NDP and all the Users you Created ...