Increase Microphone Gain (volume) on Yealink Devices

Increase Microphone Gain (volume) on Yealink Devices

Introduction

Sometimes Yealink phone users complain that the remote side of the call has difficulty hearing b/c the volume is too low. You can raise the microphone gain on the Handset, Headset or Handsfree (Speaker) by following these steps 

Procedure

  1. Press the OK button on your phone and not the IP address of the device. 
  2. Open a browser window and navigate to the IP address that you previously noted
  3. Enter the username and password (admin/773771) for most users
  4. Navigate to Features > Audio 
  5. Change the Gain between -50 and 50 on any of the settings and test

If you are unable to access the GUI, please email helpdesk@pressone.net or raise a ticket at https://support.pressone.net
    • Related Articles

    • Pair Handset with Yealink W60B

      How to register a Yealink handset with a single W60B or multiple base stations The following steps may also apply to Yealink models W52B and W80B. With a Single W60B Hold down the Connect button on the base until the top light of the three green ...
    • Adding Grandstream GXW devices to GDMS

      Fun fact if anyone ever wants to use GDMS for the GXW gateways. The process is a bit backwards. Do not add the gateway to GDMS until you manually provision the device. Add your users in the Domain Add your Gateway in NDP and all the Users you Created ...
    • Enabling and Setting Up Wifi on your Yealink T53W, T54W, T57W and Wifi Adapter enabled IP Phones

      Enabling Wifi on Yealink SIP-T53W, T54W, T IP Phone Go to Menu > Basic > Wi-Fi (for the T53W, Menu > Settings > Basic Settings > WiFi) Choose [x] Available Network[s], where "x" is the number of available networks Choose Enter Choose the Desired ...
    • Microsoft Licensing for the PBX and SIP Trunk Connector

      Microsoft Licensing for the PBX and SIP Trunk Connector These are the licenses and combinations that allow the use of Microsoft Direct Routing. The Phone System add-on license is required per user to enable the native dial-pad in Teams. Note that ...